When using rough terrain scissor lifts, it is important to utilize extra care and be completely aware of your environment so as to maintain safety. The long booms on the machinery act as levers from the center of the drive unit. For instance, a 6 inch bump could lead to a 3 foot bounce when the driver is at the driver controls. Take into consideration all other traffic in the vicinity, as they may not be aware that you are moving. Plan your assent cautiously. Park the boom lift on a flat surface which has no mud or water. These areas cover deep potholes which can be probably cause the occupants to fall if the tires fell into the holes. If provided, use all of the outriggers, extended to their full extension position. Be sure to only use wooden chalk blocks that are approved.
A lot of lifts work from a metal platform on the end of the boom. The long booms act as levers from the drive unit's center. A 6-inch bump could result in a 3-foot bounce while you are at the driver controls. Consider all other traffic. They may not be aware that you are moving. Plan your assent. Park the boom lift on a flat surface free of any water or mud. These areas could conceal deep potholes in which the lift tires could fall, tipping the occupants. Extend all outriggers, if provided, fully. Place only approved wooden chalk blocks beneath the outrigger pads in order to prevent the unit from moving.
Overhead power lines are a serious hazard for lift drivers regardless of what lift is being used. For example, if the platform operator is not being aware, or if the platform is being controlled by personnel on the ground that could not correctly access nearness to wiring and thus, either the platform itself or the worker could be easily brought into contact with electrical wires. The worker might be electrocuted unfortunately unless properly insulated.