Change a Propane Tank
Propane fueled forklifts are normally utilized inside warehouses. The lift truck is designed with the propane tank mounted at the back of the operator. The tanks, which look much like beer kegs, need to be replaced from time to time as they have a limited lifespan. Drivers of forklifts should utilize caution when handling propane tanks. Compressed gases are really hazardous, particularly since the gas is flammable. Utilize caution when replacing and removing propane tank to avoid being injured.
1 If there is a need to replace the propane tank, the first step is to stop the forklift, then turn off the tank valve. The lift truck must be left on until the engine dies. This procedure burns the gas off in the transfer hose which connects the tank and the engine. Prior to taking the second steps, put on the correct safety equipment, like insulated gloves made of either neoprene or leather. It is really essential for you to protect your skin from contact with the compressed gas, which is very cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, reconnect the holding straps and reconnect the hose at the valve of the tank by tightening the nut.
3 Leaks could be checked simply by applying soapy water to the valve and slightly opening it. If there is a leak, it will cause bubbles to foam from around the valve. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the area of the valve, and afterward perform the leak inspection procedure once more. Persistent leaks mean that both the nut and connecting hose will have to be replaced. Then again, if replacing the hose and nut still does not stop the leak, the tank must be replaced.
4 Open the valve all the way to allow the gas to fill the connecting hose. After that you can start the lift truck and continue working.